Here I am with a new advertisement dated 1913.
Mr. Ferrari was manufacturing and selling of the first radiator 900.
In fact, as our radiators were used but the physical principle called "radiator".
fact, the radiator is the phenomenon in which a hydraulic system is established as a result of convective circulation only difference in density between fluid volumes at different temperatures. In common usage the term has been extended radiator to indicate the individual radiators or radiators, although in many cases the system does not adopt the principle of the same name.
But how does the radiator?
Consider a closed loop disposed on a vertical plane. If a warmer side of the pipe, the water inside the density decreases and tends to rise at the top of the ring, pushing down the water cooler already.
The water reached the top of the opposite half of the Ring (cold side) begins to lose heat to the outside, increasing density and down toward the bottom of the circuit. From here it is invoked to replace the water heater because of moves at the top, completing the cycle.
In the past this principle was widely used in heating systems. The salt water heated by the boiler to the radiators located in the housing units. Here it releases heat, increases in density and can then fall back towards the boiler.
is preferred in modern plants cause water circulation by means of pumps, according to a solution called "forced movement". The forced circulation provides several advantages, including a water flow faster than the ability to feed radiators can also sit at the same level or even lower than the boiler, as happens in small autonomous systems.
This article is published under the "GNU Free Documentation License" .
It also uses material taken from Wikipedia article: "The radiator.
Mr. Ferrari was manufacturing and selling of the first radiator 900.
In fact, as our radiators were used but the physical principle called "radiator".
fact, the radiator is the phenomenon in which a hydraulic system is established as a result of convective circulation only difference in density between fluid volumes at different temperatures. In common usage the term has been extended radiator to indicate the individual radiators or radiators, although in many cases the system does not adopt the principle of the same name.
But how does the radiator?
Consider a closed loop disposed on a vertical plane. If a warmer side of the pipe, the water inside the density decreases and tends to rise at the top of the ring, pushing down the water cooler already.
The water reached the top of the opposite half of the Ring (cold side) begins to lose heat to the outside, increasing density and down toward the bottom of the circuit. From here it is invoked to replace the water heater because of moves at the top, completing the cycle.
In the past this principle was widely used in heating systems. The salt water heated by the boiler to the radiators located in the housing units. Here it releases heat, increases in density and can then fall back towards the boiler.
is preferred in modern plants cause water circulation by means of pumps, according to a solution called "forced movement". The forced circulation provides several advantages, including a water flow faster than the ability to feed radiators can also sit at the same level or even lower than the boiler, as happens in small autonomous systems.
This article is published under the "GNU Free Documentation License" .
It also uses material taken from Wikipedia article: "The radiator.
0 comments:
Post a Comment